Table of Contents
Advertisement
6. Carefully slide the belt onto the chopper shaft. Do not
rotate the chopper shaft.
7. While tensioning the right side of the belt, slide the
bottom of the belt into the grooves of the brush pulley.
Do not rotate the brush pulley.
8. While pushing the idler pulley into the belt, tighten the
nut on the idler pulley.
Brush to Rotating Corner Belt
To tension the belt, do the following:
1. Remove the belt cover
2. Loosen the nut on the idler pulley
Figure 61
1. Brush to rotating corner
belt cover
2. Brush to rotating corner
belt
3. Push the idler pulley into the belt and tighten the idler
pulley nut
Figure
61).
4. Install the belt cover.
(Figure
61)
(Figure
61).
3. Idler pulley
4. Nut
Hydraulic System
Maintenance
Checking the Hydraulic Lines
and Hoses
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
• Make sure that all hydraulic fluid hoses and
lines are in good condition and all hydraulic
connections and fittings are tight before
applying pressure to the hydraulic system.
• Keep your body and hands away from pin
hole leaks or nozzles that eject high-pressure
hydraulic fluid.
• Use cardboard or paper to find hydraulic leaks.
• Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic
system.
• Get immediate medical help if fluid is injected
into skin.
Check the hydraulic lines and hoses daily for leaks, kinked
lines, loose mounting supports, wear, loose fittings, weather
deterioration, and chemical deterioration. Make all necessary
repairs before operating the machine.
44
Advertisement
Table of Contents
