Table of Contents
Advertisement
7
Mounting the Core Processor
to the Workman Vehicle
Parts needed for this procedure:
1
Hitch pin (included with the tow hitch)
1
Lynch pin (included with the tow hitch)
12
Cable tie
Procedure
Note: The core processor must be equipped with the Tow
Hitch Kit (Model 09750) before it can be mounted to the
vehicle.
1. Back the vehicle into position in front of the core
processor. Make sure that the processor brush is set
for the correct height of cut.
2. Adjust the processor hitch tongue to the same level as
the vehicle hitch
(Figure
Note: The core processor frame should be level with
the ground when it is on the rear roller.
3. Connect the processor hitch to the vehicle hitch with a
hitch pin and lynch pin
Figure 18
1. Processor hitch
2. Tow vehicle hitch
4. Raise the jack and secure it in the storage position
(Figure
19).
18).
(Figure
18).
3. Lynch pin
4. Hitch pin
1. Jack
5. Connect the hydraulic hoses to the vehicle quick
couplers. Make sure that the hydraulic hoses are
properly connected to the processor and the vehicle.
6. Route the control harness over the bed of the vehicle
to the operators position.
Important: Make sure that the hoses and control
harness are not kinked and that they bend freely
during operation.
7. Remove the storage pins from the front hole position
and insert into the rear hole position during operation
(Figure
20).
1. Storage pin
2. Front hole (core processor
disconnected from tow
vehicle)
8. To extend the tow hitch, proceed as follows:
A. Make sure that the latch-handle pin is in the
unlocked (rear) position
17
Figure 19
Figure 20
3. Rear hole (core processor
connected to tow vehicle)
(Figure
21).
Advertisement
Table of Contents
