Toro ProCore Processor Operator's Manual page 37

2. Turn the key in the ignition switch to the O
and remove the key.
3. Wait for all moving parts to stop before leaving the
operating position.
4. Clean around the oil dipstick
cannot fall into the filler hole and damage the engine.
Figure 46
1. Oil dipstick
5. Remove the oil dipstick and wipe the end clean
46).
6. Slide the oil dipstick fully into the filler tube
7. Pull the dipstick out and look at the end. If the oil level
is low, slowly pour only enough oil into the filler tube
to raise the level to the F
Important: Do not overfill the crankcase with oil
and run the engine; engine damage can result.
Changing the Oil
Service Interval: After the first 8 hours
Every 100 hours
1. Turn the key in the ignition switch to the O
and let it run for 5 minutes.
Note: Letting the machine run allows the oil to warm
so that it drains better.
2. Park the machine so that the drain side is slightly lower
than the opposite side to ensure that the oil drains
completely.
3. Turn the key in the ignition switch to the O
remove the key, and wait for all moving parts to stop
before leaving the operating position.
4. Place a pan below the drain plug
5. Remove the oil drain plug allowing the oil to drain into
the pan.
6. When oil has drained completely, install the drain plug.
Note: Dispose of the used oil at a recycling center.
position,
FF
(Figure 46) so that dirt
2. Filler tube
(Figure
(Figure
mark.
ULL
position
N
position,
FF
(Figure 47).
1. Oil drain plug
7. Slowly pour approximately 80% of the specified oil
into the filler tube
8. Check the oil level; refer to
Level (page
9. Slowly add the additional oil until it reaches the Full
mark.
Changing the Oil Filter
Service Interval: Every 200 hours
Note: Change the oil filter more frequently when the
operating conditions are extremely dusty or sandy.
46).
1. Drain the oil from the engine; refer to
Oil (page 37).
2. Remove the old filter and wipe the surface of the
filter-adapter gasket
1. Oil filter
2. Adapter gasket
3. Pour new oil in through the center hole of the filter
unit it reaches the bottom of the threads inside.
4. Allow the filter material to absorb the new oil for 1
to 2 minutes.
5. Apply a thin coat of new oil to the rubber gasket on
the replacement filter
6. Install the replacement oil filter to the filter adapter,
turn the oil filter clockwise until the rubber gasket
37
Figure 47
(Figure 46).
Checking the Engine-Oil
36).
(Figure 48).
Figure 48
3. Adapter
(Figure 48).
Changing the