Toro ProCore Processor Operator's Manual page 43

8. Install the belt cover.
Chopper to Brush Belt
To adjust or install the belt, do the following:
1. Remove the belt cover
1. Chopper to brush-belt
cover
2. Idler pulley
2. Loosen the nut on the idler pulley
3. Slide the belt off of the chopper shaft and brush pulley
(Figure 59).
4. Rotate the brush pulley until a brush row is aligned
with the rotating corner
1. Brush row
2. Rotating corner
5. Rotate the chopper until a blade tip is aligned with the
outside of the brush housing
43
(Figure 59).
Figure 59
3. Nut
4. Chopper to brush belt
(Figure 59).
(Figure 60).
Figure 60
3. Blade tip
4. Brush housing
(Figure 60).