Product Overview; Controls - Toro ProCore Processor Operator's Manual

Product Overview

Controls

Brush/Chopper
Note: There are no controls to turn the brush/chopper O
or O . The brush/chopper engages when you increase the
FF
engine speed; it decreases when you move the throttle to low
idle or you stop the engine.
Lift/Offset Controls
The lift/offset functions run off the tow vehicle hydraulic
system. Refer to the tow vehicle Operator's Manual for
hydraulic system control information.
Note: The lift/offset control only functions when the core
processor engine switch is in the O
Lift/offset switch
The lift/offset switch (Figure
system to operate in the lift or offset mode.
Engine Stop Switch
Press the switch to stop the engine
Figure 25
1. Lift/offset switch
Important: If you need to stop quickly, lift the aerator
and then stop the tractor. If you stop the tractor before
you lift the aerator, the turf will be damaged.
Choke Control
To start a cold engine, pull choke-control lever
out to the O position.
N
position.
N
25) allows tow vehicle hydraulic
(Figure 25).
2. Engine stop switch
(Figure
Ignition Switch
The ignition switch
stop the engine, has 3 positions: O
the key to the S
Release the key when the engine starts. The key moves
automatically to the O
throttle control to the S
N
to decelerate and then turn the key to the O
Throttle Control
The throttle (Figure
speeds. To increase the engine speed, move the throttle lever
to the F position. To decrease the engine speed, move the
AST
throttle lever to the S
at full throttle.
1. Throttle control
2. Choke control
Hour Meter
The hour meter
machine operation.
26)
1. Hour meter
20
(Figure 26) which is used to start and
, R
FF UN
position to engage the starter motor.
TART
position. To shut engine off, move
N
position and wait for the engine
LOW
26) is used to operate engine at various
position. Always run the engine
LOW
Figure 26
3. Ignition switch
(Figure 27) indicates the total hours of
Figure 27
and S . Turn
TART
position.
FF