Panasonic KX-TVM50 Programming Manual page 121

Value Range
Max. 20 digits consisting of 0–9,
S: Skip (ignore) the code.
K: Keep the code as it is.
Dialling Parameters
Number of Digits to Access Outside Line
Specifies the number of digits necessary to access a Trunk. The VPS can discriminate between local
and long distance calls and can report outgoing calls and calling times for billing purposes on periodic
port usage reports.
Example:
If the PBX requires callers to dial "9" to access a Trunk, this parameter should be set as "1". This
enables the VPS to recognise that an outgoing call setup sequence is completed 1 time the initial "9"
has been dialled (9-123-4567). The full sequence is therefore: 9-(outgoing call setup sequence)-123-
4567.
Value Range
0–8 digits
Call Transfer No Answer Time
Specifies the length of time that the VPS must wait before retrieving the transferred call when there
is no answer at the destination extension.
Note
• Make sure that the duration of Call Transfer No Answer Time is longer than the duration of
Call Forwarding No Answer Time at the PBX. Otherwise, the PBX may forward the call
(transferred by the VPS) immediately to its destination without leaving enough time to
answer the call.
Value Range
10 s–60 s
Outgoing Call No Answer Time
Specifies the length of time that the VPS must wait before concluding that there is no answer at the
outside number called.
Value Range
10 s–90 s
Pause Time for ","
Specifies the pause time for "," used in call sequences.
, #, A–D, S (Input digit only), and K
2.5 System Parameters
Programming Guide 121