Table of Contents
Advertisement
STARTING & DRIVING
Active Speed Limit (ASL) System
1. Speed Limit Increase
2. Speed Limit Decrease
3. Cruise Cancel
4. Cruise Standby
5. Cruise Resume
206
6. Set (Activate)
7. ASL Standby
The Active Speed Limit (ASL) system is designed to control
the vehicle speed keeping it below a speed set by the driver.
The ASL system shares the same lever switch as the cruise
control system, located to the left of the steering wheel
below the indicator stalk.
between both functions, however only one function can
operate at any one time.
Activate
The desired target speed of the ASL system is displayed in
the instrument information cluster, refer to "Information
Centre" in the "Instruments and Controls" section. With
the ignition switch in position ON and the lever switch in
"ASL Standby" (7 in figure), the ASL function is in standby
mode by default, briefly moving the lever switch up/down
(1,2) adjusts the target speed of the ASL. The range of
target speed adjustment is 20 - 130mph.
The target speed limit value will be increased or decreased
by 5 mph every time the lever switch is briefly moved
upwards or downwards.
The switch can be toggled
Advertisement
Table of Contents
Need help?
Do you have a question about the ZS and is the answer not in the manual?
Questions and answers
how to work wipers
To operate the wipers on an MG ZS:
1. Select Wipe Speeds:
- Move the lever to choose different speeds:
- Intermittent Wipe (1)
- Slow Wipe (2)
- Fast Wipe
2. Single Wipe:
- Press the lever down and release for a single wipe.
- Hold the lever down for continuous high-speed wiping until released.
3. Programmed Wash/Wipe:
- Pull the lever toward the steering wheel to operate the windscreen washers.
- After a short delay, the wipers will activate and continue for three additional wipes after releasing the lever.
- A final wipe happens after a few seconds to clear any remaining fluid.
4. Rear Window Wiper Operation:
- Turn the rear wiper switch to the wash and wipe position and hold.
- The rear wiper will wipe quickly while the washer operates.
- Releasing the switch returns it to intermittent wipe mode, stopping the washer but keeping the wiper in intermittent operation.
5. Wiper Maintenance & Service Position:
- When the engine is off, activate the service position to lift the wipers for maintenance.
Avoid using wipers on a dry or frozen windscreen to prevent damage.
This answer is automatically generated
DIGITAL SPEED INDICATOR
The MG ZS features a digital speed indicator in the instrument pack. It displays the current speed digitally and allows the driver to monitor speed limits. When the Intelligent Speed Limit Assist is enabled, the system detects speed limit signs and shows the current speed limit on the digital cluster. Additionally, the speed assist system can help maintain a set speed, adjusting as needed.
This answer is automatically generated