Table of Contents
Advertisement
Tyre Pressure Monitoring System
(TPMS)
TPMS cannot replace routine maintenance
and check of the tyre condition or pressure.
If radio transmission devices such as mobile
telephones or wireless headsets are used in
close proximity to the vehicle it may result
in interference with the TPMS and could
register as a fault.
Note: TPMS only gives the driver a warning when the
tyre pressure is low, it will not inflate the tyre.
TPMS uses pressure sensors built into tyre valves to
continuously monitor pressure and transmits signal to ECU
inside the vehicle using RF signals. If it deduces that the
pressure of that tyre has fallen below the predefined limit
of the system, the warning light on the instrument pack will
illuminate (always yellow). For more information, please
refer to 'Instrument Pack' in 'Instruments and Controls'
section. Check your tyres at the earliest opportunity and
STARTING & DRIVING
reinflate to the correct pressure. Please refer to 'Tyre
Pressure (Cold)' in 'Technical Data' section.
System Malfunction
This system is self-monitoring, if a malfunction
is detected, the TPMS warning lamp (yellow) on the
instrument pack will flash for 90 seconds first and then
illuminate.
Note: When a puncture is detected, the system will
require some time to analyse information prior to
illuminating the warning lamp.
Under certain conditions the warning light may illuminate
when a fault is not present, these conditions include:
• A non recommended tyre fitted (including spare tyre).
• Rough terrain driving for excessive periods.
• Bending or mountain type terrain driving for excessive
periods.
• TPMS will not respond immediately if a tyre 'blows out'.
4
213
Advertisement
Table of Contents
Need help?
Do you have a question about the ZS and is the answer not in the manual?
Questions and answers
how to work wipers
To operate the wipers on an MG ZS:
1. Select Wipe Speeds:
- Move the lever to choose different speeds:
- Intermittent Wipe (1)
- Slow Wipe (2)
- Fast Wipe
2. Single Wipe:
- Press the lever down and release for a single wipe.
- Hold the lever down for continuous high-speed wiping until released.
3. Programmed Wash/Wipe:
- Pull the lever toward the steering wheel to operate the windscreen washers.
- After a short delay, the wipers will activate and continue for three additional wipes after releasing the lever.
- A final wipe happens after a few seconds to clear any remaining fluid.
4. Rear Window Wiper Operation:
- Turn the rear wiper switch to the wash and wipe position and hold.
- The rear wiper will wipe quickly while the washer operates.
- Releasing the switch returns it to intermittent wipe mode, stopping the washer but keeping the wiper in intermittent operation.
5. Wiper Maintenance & Service Position:
- When the engine is off, activate the service position to lift the wipers for maintenance.
Avoid using wipers on a dry or frozen windscreen to prevent damage.
This answer is automatically generated
DIGITAL SPEED INDICATOR
The MG ZS features a digital speed indicator in the instrument pack. It displays the current speed digitally and allows the driver to monitor speed limits. When the Intelligent Speed Limit Assist is enabled, the system detects speed limit signs and shows the current speed limit on the digital cluster. Additionally, the speed assist system can help maintain a set speed, adjusting as needed.
This answer is automatically generated