Table of Contents
Advertisement
INSTRUMENTS AND CONTROLS
Rear Window Wiper Operation
• Intermittent wipe (1)
• Wash and wipe (2)
• Wash and wipe (3)
• Intermittent wipe frequency adjustment (4)
The rear window wiper and washer will only operate with
the ignition switch in the ON position. Turn the rear
window wiper switch to intermittent wipe (1), the rear
window wiper will operate, after 3 consecutive wipes, the
40
wipers will enter into intermittent mode. The time period
between the wipes can be increased/decreased via the
intermittent wipe frequency adjustment switch (4).
Turn the rear window wiper switch to wash and wipe (2)
position and hold, the rear window wiper and washer will
operate, the rear window wiper wipes quickly. release the
switch allowing it to return to intermittent wipe (1), the
rear window washer will stop operating, and the wiper
wipes slowly, change the stalk switch position 4
the wipe speed.
Turn the rear window wiper switch to wash and wipe (3)
and hold, the rear window wiper and washer will operate.
release the switch allowing it to return to OFF position,
the rear window washer will stop operating, and the rear
window wiper wipes for 3 times, after several seconds, the
wiper will wipe once more to remove the washer fluid on
the windscreen.
*
Note: When the tailgate is opened, rear window wiper
operations will be disabled.
*
to adjust
Advertisement
Table of Contents
Need help?
Do you have a question about the ZS and is the answer not in the manual?
Questions and answers
how to work wipers
To operate the wipers on an MG ZS:
1. Select Wipe Speeds:
- Move the lever to choose different speeds:
- Intermittent Wipe (1)
- Slow Wipe (2)
- Fast Wipe
2. Single Wipe:
- Press the lever down and release for a single wipe.
- Hold the lever down for continuous high-speed wiping until released.
3. Programmed Wash/Wipe:
- Pull the lever toward the steering wheel to operate the windscreen washers.
- After a short delay, the wipers will activate and continue for three additional wipes after releasing the lever.
- A final wipe happens after a few seconds to clear any remaining fluid.
4. Rear Window Wiper Operation:
- Turn the rear wiper switch to the wash and wipe position and hold.
- The rear wiper will wipe quickly while the washer operates.
- Releasing the switch returns it to intermittent wipe mode, stopping the washer but keeping the wiper in intermittent operation.
5. Wiper Maintenance & Service Position:
- When the engine is off, activate the service position to lift the wipers for maintenance.
Avoid using wipers on a dry or frozen windscreen to prevent damage.
This answer is automatically generated
DIGITAL SPEED INDICATOR
The MG ZS features a digital speed indicator in the instrument pack. It displays the current speed digitally and allows the driver to monitor speed limits. When the Intelligent Speed Limit Assist is enabled, the system detects speed limit signs and shows the current speed limit on the digital cluster. Additionally, the speed assist system can help maintain a set speed, adjusting as needed.
This answer is automatically generated