Installation - Mitsubishi Electric AE-SW Series Instruction Manual

Installation

< Drawout type >
Tolerance on support flatness ≤ 1 mm
Fig. 7-1
In the case of AE4000 ~ 6300-SW, insert four M12 bolts from the bottom and two M12 bolts from the back to mount the
cradle as shown in Fig. 7-3. In the case of 4P FN type, insert six M12 bolts from the bottom and two M12 bolts from the
back to mount the cradle as shown in Fig. 7-4.
~
AE4000 6300-SW 3P & 4P (HN)
Cradle
Mounting angle (Non-magnetic)
Fig. 7-3
Operate the drawout operation (CONNECT position to DRAWOUT position) according to instructions of drawout
operation. (Refer to P.13 and 14.)
Lifting by lifting truck or lifting hooks
Lifting
Fig. 7-5
< Fixed type >
M12
M8
Earthing
terminal
Fig. 7-8
AE630-SW〜AE4000-SWA
M12
AE4000
2-M12
4-M12
CAUTION
Falling
When the main body is drawn out,
the center of gravity shifts to the
front. If the cradle is not secured,
take measures against overturning
and dropping.
Fig. 7-6
M8
Earthing terminal
Fig. 7-2
~
6300-SW 4P (FN)
Mounting angle (Non-magnetic)
Fig. 7-4
CAUTION
O n A E 4 0 0 0 - S W A , A E 4 0 0 0 - S W ~
AE6300-SW, the center of gravity of the
cradle is located at the terminal posi-
tion. When the main body is removed
from the cradle, the cradle may turn over
backward. Take measures against
overturning.
Fig. 7-7
2-M12
6-M12
Support
E − 7