GE LOGIQ E9 Service Manual page 461

GE
D 5573152-100, R
IRECTION
8-6-11-4 Gel Warmer removal
1.) Remove the Bulkhead Cover.
2.) Disconnect the Gel Warmer cable from (P1) on the back of the bulkhead.
3.) The Gel Warmer cable is routed through the cable channel (1) and the lower frame support (2). Pull
the Gel Warmer cable through the lower frame cable support to free the cable.
4.) Remove the Options Holder
8-172).
5.) Remove the two screws at the Gel Warmer base.
6.) Lift the Gel Warmer out of the Options Holder.
. 2
EV
Figure 8-38 Gel Warmer Cable placement
Figure 8-39 Options Holder removed, with Gel Warmer in place
Chapter 8 Replacement procedures
(8-6-10 "Options Holder / Left or Right Support replacement" on page
LOGIQ E9 S M
ERVICE ANUAL
8 - 177