GE LOGIQ E9 Service Manual page 387

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5573152-100, R

NOTE: To ensure the Monitor is installed

level with the system and before

re- installing the Cable Cover:

- the LOGIQ E9 is on a level surface,

- the wheels are in-line,

- the Monitor Arm Lock is LOCKED.

Check that the LOGIQ E9 is level.

Place a level on the monitor (as shown).

If any adjustment is required, loosen the

four mounting screws and make the

adjustment. Re-tighten the four screws

after the adjustment.

NOTE: If a level is not available, make sure

the Monitor is as square as possible with

the LOGIQ E9, visually.

Monitor installation - R5.x and later (Ergotron)

Chapter 8 Replacement procedures

Corresponding Graphic