GE LOGIQ E9 Service Manual page 190

GE
D 5573152-100, R
IRECTION
6-3-3 LCD Arm and LCD Monitor Tilt adjustment - Original Arm
Table 6-7
1.
Confirm LCD Arm and LCD Monitor
have full range of motion.
Move the LCD arm from side to
side.
Move the LCD from a face forward,
vertical position to a face down,
horizontal position.
Remove the Monitor Rear Cover.
Too tight:
If the customer finds the LCD
difficult to move from a vertical to
horizontal position, use a 17 mm
wrench to loosen nuts at hinge. Be
sure to loosen both sides equally.
Start with 1/4 turn and test full 90
degree movement before loosening
more.
Too loose:
If the customer finds the LCD does
not remain in place after adjusting
the LCD from a vertical to horizontal
position, use a 17 mm wrench to
tighten nuts at hinge. Be sure to
tighten both sides equally. Start with
1/4 turn and test full 90 degree
movement before tightening
more.NOTE: If the monitor is not
level, see:
installation - R3.x and earlier" on
page 8-89
6 - 14 Section 6-3 - Monitor Arm and/or Monitor range of motion Adjustment procedure
. 2
EV
LCD Arm and LCD Monitor Tillt adjustment
Steps
8-6-2-2 "LCD Monitor
to level the monitor.
LOGIQ E9 S
Corresponding Graphic
LCD in vertical position
LCD Hinge Nuts
M
ERVICE ANUAL