Mitsubishi Electric MP-G10-AH Technical Manual page 15

7. Stitching test
(1) Select the stitching pattern.
(Refer to the PLK-G1010 Control section instruction manual.)
(2) Set the material to be stitched, and then press the [Black] side of the 2-pedal foot switch to
lower the work holder.
(3) Set the label under the label holder plate, and then press the 1-pedal foot switch to lower the
label holder.
(If the position of the label deviates due to the thrust when the label holder losers, adjust the
lowering speed with the speed controller at the Fig. No. 109 air cylinder in the work holder
mechanism.)
(4) Press the [Gray] side of the 2-pedal foot switch to rotate the sewing machine and start
stitching.
(Stitching will not start unless the work holder and label holder are lowered.)
(5) The flip-flop shaft will rotate at the position where the reverse signal is issued in the stitching
pattern.
(6) When stitching is completed, the sewing machine will automatically return to home position,
and the holders will rise.
- 13 -