Mitsubishi Electric MP-G10-AH Technical Manual page 9

Cable Signal name
Work holder input 2
(I8)
＋24V
Work holder output 1
(O4)
＋24V
Label holder output 2
(O5)
＋24V
Flip-flop shaft rotation
output 3
(O7)
4.4 Removing the standard parts
When this label holder unit is mounted, the presser foot and wiper drive mechanism
mounted on the sewing machine head cannot be used and must be removed.
To remove these parts, refer to the part catalog P-246 for the PLK-G1010 sewing machine
unit, and remove the parts including Fig. No. M111 presser foot, Fig. No. M112 needle guard,
Fig. No. M113 screw and Fig. No. N124 wiper.
4.5 Installing the system software
When this sewing machine is already used, installation explained by this clause
is not necessary.
① While holding down the [F] key on the front panel of the control box, turn the machine power
ON.
(Keep pushing [F] key until red LED on the front panel is turned on.)
② [Model and language set function] screen is displayed.
③ Press the
the .
④ Press the
the .
⑤ Press the
⑥ After [INITIALIZES SET VALUE] message is displayed, press the
This completes installing the system software. Turn off the power switch once.
0V
Sewing machine head connector PCB
Sewing machine head connector PCB
On machine head PCB terminal block
On machine head PCB terminal block
On machine head PCB terminal block
On machine head PCB terminal block
. Select the
1010
. Select the
to determine the settings.
Connection
Sewing machine head Connector
CON L (12P) - ①
Sewing machine head Connector
CON L (12P) - ②
CON13 (FU)－②
CON13 (FU)－①
CON15 (OP1) - ③
CON15 (OP1) - ①
CON14 (OP2) - ③
CON14 (OP2) - ①
on the language set function screen then, press
on the model set function screen then, press
- 7 -
White
Black
Solenoid
valve
White
Blac k
Solenoid
White valve
Black
Solenoid
valve
White
Black
.