Table of Contents
Advertisement
5. Home position
5.1 Adjusting the home position
If the machine's home position is at the same position even if the label size changes, it will
be easier to make a clamp and change it. Thus, change the home position in anticipation of
the maximum size.
The relation of the work holder, stitching area and home position is as shown below.
(1) The optimum range for moving the home position is shown as the shaded section. Note that
when considering the label size, the home position should be moved at a position within the
shaded area at least 4mm or more away from the label holder plate when the No.140 label
holder plate overlaps the shaded area or when it is near this area.
(2) Refer to the PLK-G1010 Sewing machine head instruction manual (7-21 Adjustment of the
X-Y mechanical home position), and adjust the home position.
5.2 Return to home position
(1) Turn the sewing machine power switch ON.
(2) Confirm that the work holder lowers when the foot switch (2-pedal) [Black] side is turned
ON, and rises when the switch is turned ON again
(3) Confirm that the label holder lowers when the expanded foot switch (1-pedal) is turned
ON.and rises when the switch is turned ON again. The label holder will not move even if
the foot switch is depressed unless the work holder is lowered. (If proper operation is not
possible, refer to the Setup Procedures and check the settings and connections.)
(4) Lower the work holder and label holder, and press
home position will start.
O r i g i n a l m e c h a n i c a l
h o m e p o s i t i o n
M i n i m u m s t i t c h i n g d i m e n s i o n s
Ma xi m u m s t i t c h i n g d i m e n s i o n s
on the operation panel. Return to
- 9 -
Advertisement
Table of Contents
