Installation - ABB HD5-S Original Instructions Manual

7. INSTALLATION

This chapter contains information about the installation procedures for the three-position device.

Connect the cable to the control device and connect the HD5 to the cable.

Mount the holder

Make sure that the three-position device is completely in the holder.

Make sure that the connection cable is an original cable from ABB and protected from
mechanical damage to ensure highest safety and reliability.

Make sure that the cable carrying the control signals from the three-position device is physically
separated from cables that carry power.
Attention!
Installation shall be done by an approved person. See Chapter Approved person for more information.
The position should be selected in view of ergonomic and safety relevant aspects.
Other protective measures must be taken in order to protect other people in the same or in adjacent
hazardous areas.
• The safety functions of the product must be tested before the system is put in operation.
• The safety functions of the product must be tested after installation or replacement of components or
cables.
• The safety functions and the mechanics of the product must be tested regularly to confirm that all the
safety functions are working properly.
Attention!
in accordance to the national electrical codes, cables that carry power (mains
power lines, power circuits with a high di/dt, switch-mode converters, power-
regulation control devices) and cables that carry control signals must be physically
separated.
The connection cable of this device carries control signals and must be laid in the
cable area for control signals.
2TLC010052M0201_A 19