ABB SACE Emax 2 Manual page 25

Installation menu If Ekip Touch detects that Rating Plug or Measurement module have not been installed properly, it signals an
Test Menu
About Menu
23 | © 2019 ABB | 1SDH001316R1002 - ECN000086501 - Rev. A
alarm (page 50) and completes Settings menu with the specific installation section:
Menu Submenus 1
Circuit Breaker Installation
Correct installation is confirmed by a message on the display and disappearance of the alarm signal and
installation menu.
NOTE: availability of submenus depends on the module, which appears to have not been
installed
Menu Submenus
Autotest -
Trip Test -
Test CB -
-
Ekip Signalling 4K (1)
Ekip Signalling 2K-1
Ekip Signalling 2K (1) Ekip Signalling 2K-2
Ekip Signalling 2K-3
S Protection
ZoneSelectivity (2)
G Protection
Rc Test -
(5)
(1)
available if one or more Ekip Signalling modules are connected and detected by Ekip Touch
(2)
available if Ekip Touch is on with auxiliary supply
(3)
available with S and/or S2 protection enabled and curve t=k
(4)
available with G and/or Gext protection enabled and curve t=k
(5)
available with Rating Plug and Rc sensor present
Menu Submenus
-
Protection Unit
-
Circuit Breaker
IEC61557-12 -
(1)
Feature Collection -
Modules Modul x
Load Input Status
Power Controller
(3)
Load Active
Load Input Status
Load shedding
(3)
Load Active
(1)
available if Class 1 Power & Energy Metering SW package is provided for by Trip unit module or if it has been
previously activated
(2)
available if one or more modules are connected and detected by unit
(3)
available if function has been installed and enabled in Trip unit
Submenus 2
Rating Plug
Ekip Measuring
Description, parameters and Commands
Autotest command
TRIP command
Close CB, Open CB
Module autotest command
(1)
Module autotest command
(1)
(1)
Input, Force Output, Release Output
Test instructions
Information provided
Information about Ekip Touch: Mainboard serial
number, Trip unit serial number, type, version,
standard, SW version, date and time, language
CB information: TAG name, CB name, rated current,
number of poles, CB status and position, total
operations, CB serial number
Status of 1% measurements (from Class 1 Power
& Energy Metering package), serial number of
assembly and current sensors connected
List of tripped protections in Trip unit
Module information: serial number, SW version,
(2)
status of inputs/outputs/contacts (if present)
Status of loads (open/closed)
Load configuration (activated/not activated)
Status of loads (open/closed)
Load configuration (activated/not activated)
ABB | SACE Emax 2
Commands
Install
Install
Interface and menus | 4 - Menu