Status Leds; Card Power System - Xilinx Alveo U200 User Manual

Status LEDs

The Alveo card is designed to operate with the passive heat sink enclosure cover installed so the
DS1 and DS2 LEDs are not visible. Status light emitting diodes (LEDs) DS3, DS4, and DS5 are
visible through a cutout in the PCIe end bracket. The following table defines the card status
LEDs.
Table 3: Card Status LEDs
Reference Designator

Card Power System

Limited power system telemetry is available through the I2C IP. I2C IP is instantiated during the
FPGA design process which begins after the Alveo Data Center accelerator card is selected from
the Vivado Design Suite Boards tab. Refer to
UG1289 (v1.1.1) November 20, 2019
Alveo U200 and U250 Accelerator Cards
DS1
DS2
DS3
DS4
DS5
Design Flows
Chapter 3: Card Component Description
Description
RED: POWER_GOOD
BLUE: DONE_0
ORANGE: STATUS_LED0
YELLOW: STATUS_LED1
GREEN: STATUS_LED2
for more information.
Send Feedback
www.xilinx.com
19