Functionn Test - microHAM DIGI KEYER Manual

Basic operation can be checked with the Test buttons, located on Ports tab.
FSK - test button sends ten (10) RY characters at 45.45 5/N/1.5 to the MK FSK output. The green arrow
on the Ports tab and the green FSK LED on the DIGI KEYER front panel should blink together . If
the PTT box is checked, the characters will be transmitted.
2 nd FSK - test button sends ten (10) RY characters at 45.45 5/N/1.5 to the MK FSK output. The green
arrow on the Ports tab and the green FSK LED on the DIGI KEYER front panel should blink together
. If the PTT box is checked, the characters will be transmitted.
CW - test button keys the DIGI KEYER CW output. The red arrow on the Ports tab and the red CW LED
on the DIGI KEYER front panel should light continuously. When the radio is in the CW mode and is
manually keyed (or break-in is enabled) a continuous CW carrier will be transmitted.
PTT - test button keys the DIGI KEYER PTT outputs. The PTT line that is keyed depends on the Serial
port PTT settings on the Keying tab.
If the PA PTT box is checked then the PA PTT signal for Power Amplifier will be generated on the
DIGI KEYER rear panel RCA jack.
If the LNA PTT box is checked then the LNA PTT signal for LNA bypass will be generated on the
DIGI KEYER rear panel RCA jack.
2 nd PTT - test button keys the DIGI KEYER PTT outputs. The PTT line that is keyed depends on the Serial
port PTT settings on the Keying tab.
If the PA PTT box is checked then the PA PTT signal for Power Amplifier will be generated on the
DIGI KEYER rear panel RCA jack.
If the LNA PTT box is checked then the LNA PTT signal for LNA bypass will be generated on the
DIGI KEYER rear panel RCA jack.
microHAM © 2006 All rights reserved
8 - FUNCTION CHECK
25