Table of Contents
Advertisement
microHAM Home Page - Link to
microHAM Downloads page - Link for downloading the current software and firmware updates
Show Tooltips - When checked, small, single line help is displayed below the mouse cursor
About - Shows the version number
There are three (3) tabs for configuring DIGI KEYER. Each tab controls a part of DIGI KEYER's functions.
Any change to the first two (2) tabs are applied immediately to DIGI KEYER. Changes in Messages are
NOT applied automatically. To store them use buttons Store or Store All.
Ports - used to assign virtual ports to the DIGI KEYER
for use by applications.
Keying - used to configure timing of the PTT signal,
opertion of the FSK keyboard and the audio
porcessor.
Messages – used to configure stored FSK messages.
Once the virtual ports have been created they must be associated with a specific device channel (e.g.,
Control, CW, PTT, etc.). These assignments should correspond to settings of the application software and
must be configured first in Router then in the application (e.g., logging program, MMTTY, STREAM, etc.).
Proper configuration of the COM ports assigments in this tab is most important for intergration with
loggers. Read the following information carefully.
DIGI KEYER has seven functions with indication of the state and settings applied by the host application
Radio Control (uses RxD and TxD)
–
FSK (uses TxD and optionally RTS/DTR for PTT)
–
2
nd
FSK (uses TxD and optionally RTS/DTR for PTT)
–
CW (uses DTR or RTS)
–
PTT (uses DTR or RTS)
–
2
nd
PTT (uses DTR or RTS)
–
Squelch (uses CTS, DCD, DSR or RING)
–
General note: Do not assign virtual ports to the channels which are not used by the application. It is
unnecessary and only consumes resources.
microHAM © 2006 All rights reserved
HELP MENU
www.microHAM.com
DEVICE CONFIGURATION TABS
Ports Tab
16
Advertisement
Table of Contents
