Toro T4240 Operator's Manual page 8

Note:
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. Review the instructions for operating the machine on slopes in the Operator's Manual as
well as the conditions in which you would operate the machine to determine whether you can operate the machine in the conditions
on that day and at that site. Changes in the terrain can result in a change in slope operation for the machine. If possible, keep the
cutting units lowered to the ground while operating the machine on slopes. Raising the cutting units while operating on slopes can
cause the machine to become unstable.
1. Tipping hazard—drive slowly when turning or going up slopes. 4. Warning—read the Operator's Manual; remove the key from
2. Tipping hazard—only drive up slopes that are between 0 and
18°; do not drive up slopes that are greater than 18°.
3. Tipping hazard—wear a seatbelt when the rollbar is up; do not
wear a seatbelt when the rollbar is down.
111-8098
the ignition before servicing or performing maintenance.
5. Thrown object hazard—keep bystanders away.
8
decal111-8098