Dual Lift Configuration Control; Engaging The Cutting Unit Drive - Toro T4240 Operator's Manual

Note:
If the cutting unit drive switch is in the
O position, the cylinder drive will disengage
N
when the cutting units are approximately 300
mm (11.8 inches) above ground level.
3. Release the lift-control switches when the cutting
units are at the required height.
Note:
The control switches will automatically
return to position 2 and the arms are hydraulically
locked into position.
Dual Lift Configuration
Control
The dual lift configuration control function enables the
lift controls to be used in the following ways
27):
1. 5-gang mode
2. 3/5-gang mode
3. Left lift lever
5-gang mode:
•
The left lift lever controls the left wing cutting unit.
•
The center lift lever controls the left front, center,
and right front cutting units.
•
The right lift lever controls the right wing cutting
unit.
3/5-gang mode:
•
The left lift lever controls the left wing and left front
cutting units.
•
The center lift lever controls the center cutting unit.
•
The right lift lever controls the right wing and right
front cutting units.
Figure 27
4. Center lift lever
5. Right lift lever
3/5-gang mode with left and right wing cutting
units locked in transport position:
•
The left lift lever controls the left front cutting unit.
•
The center lift lever controls the center cutting unit.
•
The right lift lever controls the right front cutting
unit.
Engaging the Cutting Unit
Drive
(Figure
1. Forward
2. Off
You can engage the cutting unit drive onlywhen
you are seated correctly, refer to
Operator Presence Controls (page
Forward rotation cutting unit drive engagement:
Press the top of the cutting unit drive switch to the
F
ORWARD
WARNING
Only operate the forward cutting unit rotation,
once the reels have completely stopped,
g029258
otherwise machine damage could occur.
Reverse rotation cutting unit drive engagement:
Press the bottom of the cutting unit drive switch to
the R
EVERSE
WARNING
Only operate the reverse cutting unit
rotation, once reels have completely stopped,
otherwise machine damage could occur.
All cutting unit drives disengagement: Set the
switch to the middle position.
To lower the cutting unit: Operate the lift-control
lever in a downward direction. The cylinder will drive
when the cutting units are approximately 300 mm
(11.8 inches) above ground level.
24
Figure 28
3. Reverse
position.
position.
g029235
Understanding the
20).