Toro T4240 Operator's Manual page 19

4-wheel drive 5-plex mower traction unit
Table of Contents

Advertisement

Operate the machine only in good visibility to avoid
holes or hidden hazards.
Avoid mowing on wet grass. Reduced traction
could cause the machine to slide.
Keep your hands and feet away from the cutting
units.
Look behind and down before backing up to be
sure of a clear path.
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
Stop the cutting units whenever you are not
mowing.
Slow down and use caution when making turns
and crossing roads and sidewalks with the
machine. Always yield the right-of-way.
Operate the engine only in well-ventilated areas.
Exhaust gases contain carbon monoxide, which
is lethal if inhaled.
Do not leave a running machine unattended.
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Disengage the cutting unit(s) and lower the
attachments.
– Engage the parking brake.
– Shut off the engine and remove the key (if
equipped).
– Wait for all movement to stop.
Operate the machine only in good visibility and
appropriate weather conditions. Do not operate
the machine when there is the risk of lightning.
Rollover Protection System
(ROPS) Safety
Do not remove the ROPS from the machine.
Ensure that the seat belt is attached and that you
can release it quickly in an emergency.
Check carefully for overhead obstructions and do
not contact them.
Keep the ROPS in safe operating condition by
thoroughly inspecting it periodically for damage
and keeping all the mounting fasteners tight.
Replace a damaged ROPS. Do not repair or alter
it.
Machines with a Foldable Roll Bar
Always use the seat belt with the roll bar in the
raised position.
The ROPS is an integral safety device. Keep a
folding roll bar in the raised and locked position,
and use the seat belt when operating the machine
with the roll bar in the raised position.
Lower a folding roll bar temporarily only when
necessary. Do not wear the seat belt when the
roll bar is folded down.
Be aware that there is no rollover protection when
a folded roll bar is in the down position.
Check the area that you will be mowing and never
fold down a folding roll bar in areas where there
are slopes, drop-offs, or water.
Slope Safety
Slopes are a major factor related to loss of control
and rollover accidents, which can result in severe
injury or death. The operator is responsible for
safe slope operation. Operating the machine on
any slope requires extra caution.
Evaluate the site conditions to determine if the
slope is safe for machine operation, including
surveying the site. Always use common sense
and good judgment when performing this survey.
Review the slope instructions listed below for
operating the machine on slopes and review the
conditions in which you will operate the machine
to determine whether you can operate it in the
conditions on that day and at that site. Changes
in the terrain can result in a change in slope
operation for the machine.
Avoid starting, stopping, or turning the machine on
slopes. Avoid making sudden changes in speed or
direction. Make turns slowly and gradually.
Do not operate a machine under any conditions
where traction, steering, or stability is in question.
Remove or mark obstructions such as ditches,
holes, ruts, bumps, rocks, or other hidden hazards.
Tall grass can hide obstructions. Uneven terrain
could overturn the machine.
Be aware that operating the machine on wet
grass, across slopes, or downhill may cause the
machine to lose traction. Loss of traction to the
drive wheels may result in sliding and a loss of
braking and steering.
Use extreme caution when operating the machine
near drop offs, ditches, embankments, water
hazards or other hazards. The machine could
suddenly roll over if a wheel goes over the edge
or the edge caves in. Establish a safety area
between the machine and any hazard.
Identify hazards at the base of the slope.
If there are hazards, mow the slope with a
pedestrian-controlled machine.
If possible, keep the cutting unit(s) lowered to the
ground while operating on slopes. Raising the
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

02750

Table of Contents