After Operation; After Operation Safety - Toro T4240 Operator's Manual

continuing operation. Serious damage could occur if
you operate the machine with a malfunction.
Mowing Grass
The rotational speed of the cutting cylinders should
always be kept as high as possible in order to maintain
the highest quality of cut. This in turn requires that the
engine speed be kept as high as possible.
Cutting performance is best when cutting against the
lie of the grass. In order to take advantage of this fact,
the operator should attempt to alternate the direction
of mowing between cuts.
Take care not to leave uncut strips of grass at the
overlap points between adjacent cutting units by
avoiding tight turns.
Maximizing the Quality of Cut
The quality of cut will deteriorate if the forward speed
is excessive. Always balance the quality of cut with
the work rate required and set the forward speed
accordingly.
Maximizing Engine Efficiency
Do not let the engine labor. If you notice that the
engine starts to labor, reduce the forward speed or
increase the height of cut. Check that the cutting
cylinders are not in heavy contact with their bottom
blades.
Driving the Machine in Transport
Mode
Always disengage the cutting unit drive when traveling
across un-grassed areas. Grass will lubricate the
cutting edges whilst mowing. Excessive heat will build
up if the cutting cylinders are run when not mowing
and this will cause rapid wear to take place. For this
reason it is also wise to reduce cutting speed when
mowing lightly grassed areas or when the grass is
dry. Be careful when driving between objects so that
you do not accidentally damage the machine or the
cutting units.
WARNING
Take care when traveling over obstacles such
as roadside curbs. Always travel at slow
speed over obstacles to prevent damage to
the tires, wheels, and steering system. Ensure
that the tires are inflated to the recommended
pressures.
Operating the Machine on Slopes
Use extra care when operating the machine on slopes.
Drive slowly and avoid sharp turns on slopes to
prevent rollovers. Lower the cutting units for steering
control when going downhill.
Using the Rear Roller Scrapers
It is generally wise to remove rear roller scrapers
where conditions allow, as optimum grass discharge
is achieved without them. Install the scrapers when
conditions are such that mud and grass start to build
up on the rollers. When installing the scraper wires,
ensure that they are correctly tensioned.

After Operation

After Operation Safety

General Safety
•
Shut off the engine, remove the key (if equipped),
and wait for all movement to stop before you leave
the operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the cutting units,
drives, mufflers, cooling screens, and engine
compartment to help prevent fires. Clean up oil or
fuel spills.
•
Shut off the fuel while storing or transporting the
machine.
•
Disengage the drive to the attachment whenever
you are transporting or not using the machine.
•
Maintain and clean the seat belt(s) as necessary.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
26