GE DMS Go Operator's Manual page 87

2.5.1b Zeroing Out the Probe (PROBE & CAL - PROBE ZERO)
IMPORTANT: This option is only available if the Zero option (see page 60) in the 1-point calibration mode has been set to Manual or User.
In the MAIN menu, scroll to the PROBE & CAL submenu using the joystick (
1.
2. Use the joystick (
3. The menu now varies.
If you have selected Manual in the Zero function, a message appears, "Put probe on zero block -- use
couplant." Put the probe on the zero block on the DMS Go stand (see the figure at right), apply
couplant to the probe, and take the measurement.
4. If you have selected User in the Zero option, the message reads, "Wipe off Couplant from Probe, Press
Zero."
5. The DMS Go zeroes out the probe. After completing the measurement, use the joystick (
move to another function, or press HOME to return to the Main Menu.
DMS Go Operator's Manual
Your Complete Source for
Testing Equipment. Since 1969!
) to select the PROBE ZERO function, then use the joystick (
www.BergEng.com
Berg Engineering & Sales Company, Inc.
Chapter 2. Instrument Setup
).
) to select Start.
) to
Zero
Block
65
1-847-577-3980
Info@BergEng.com