Huawei iBAT 2.0-CIM01C2 Quick Manual page 15

Networking
2. Press the BIM networking switch for 2 seconds. When the RUN/ALM indicator turns from steady
red to blinking green at super short intervals, and finally to blinking green at long intervals, the
BIM connects to the CIM network.
•
It is recommended that BIMs be
networked from the positive battery
string terminal according to the battery
cable connection sequence.
•
Batteries are numbered depending on
the sequence of connecting BIMs to
the CIM.
3. Perform networking operations on the next BIM only after networking for the previous BIM is
successful. Repeat step 2 to add other BIMs to the CIM network.
4. Press the CIM networking switch for 2 seconds. When the RF_Z indicator on the CIM turns from
blinking green at super short intervals to blinking green at long intervals, the networking is
complete.
After the networking is complete, the number of devices online is smaller than the value of iBAT
Number of iBOX if the ALM indicator on the CIM is steady on. Check that iBAT Number of iBOX
is correctly set and that the BIM is successfully networked.
5. (Optional) If multiple CIMs are cascaded, repeat step 1 to step 4 to network remaining CIMs and
BIMs.
6. (Optional) On the CIM WebUI home page, choose System settings > Running Parameter >
iBAT Parameters Config, and set Batt. undervolt. protect thres..
•
For a data center, you are advised to set Batt. undervolt. Protect thres. to 1.6 V/cell.
•
If Batt low volt protection point cannot be set, check whether the BIM Comm. Failure alarm
is generated.
ALM
switch indicator
RF_Z
indicator
•
Blinking at long intervals: The
indicator is on for 1 second and
then off for 1 second alternately.
•
Blinking at super short intervals:
The indicator is on for 0.05
second and then off for 0.05
second alternately.
RUN/ALM
indicator
HUAWEI TECHNOLOGIES CO., LTD.
Huawei Industrial Base, Bantian, Longgang
15
Networking
switch
Shenzhen 518129
People's Republic of China
e.huawei.com