Table of Contents
Advertisement
6. Access the System Settings page, and set the Time and IP Address parameters according to
the following table.
System Settings
Time
IP Address
7.
On the iBOX WebUI, Choose System Settings > Battery Curve.
8.
On the Battery Curve page, select the battery string to be set, set Battery Brand and Format,
click Filter > Submit.
7.3
CIM and BIM Networking
Before networking, ensure that all the CIMs and BIMs have no network parameters, that is, the
RF_Z indicator on the CIM is steady green and the RUN/ALM indicator on the BIM is steady red.
•
If the RF_Z indicator on the CIM is not steady green, hold down the networking switch on the
CIM for 10–20 seconds to clear the original network.
•
If the RUN/ALM indicator on the BIM is not steady red, hold down the BIM networking switch for
at least 5 seconds to clear the original network.
•
To prevent the BIM in a different group connecting to another CIM, ensure that only one CIM is
under networking at a time. That is, only the RF_Z of this CIM is blinking at super short intervals.
•
Do not operate the networking switch during networking. Otherwise, the networking fails.
1. Press the CIM networking switch for 2 seconds. The ALM indicator blinks red once, and the
RF_Z indicator turns from steady green to blinking green at super short intervals, which
indicates that the CIM is being networked.
Description
Set the local time zone, date, and time.
Set the IP address, subnet mask, and default gateway of the iBOX. Set
this parameter based on the IP address assigned by the administrator.
14
Advertisement
Table of Contents
