Notes About Acknowledgment (Configuration) - Siemens SINUMERIK 840D sl Operating Manual

Buttons for the package execution dialogs
Note
The buttons are identical for all dialog pages of package execution and thus have the same
meaning.
Table 4-18
Button
Output
Alarms
Log...
Back / Next
Cancel
4.4.2.6

Notes about acknowledgment (configuration)

The "Notes about acknowledgment" dialog contains notes for the operator that must be
acknowledged before the package execution can be continued.
You can configure the following property group for the "Notes about acknowledgment" dialog
page:
● Dialog
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 12/2017, A5E36537479B-AE
Meaning of buttons
Meaning
The output window is shown or hidden. Status messages are displayed in
the output window while the package is being executed.
The alarm list can be displayed or hidden. It displays errors and messages
from NC, PLC, drive and HMI.
The alarm list approximately corresponds to the "Diagnostics" used in SIN‐
UMERIK Operate.
This button opens the CMC logbook for package execution.
These buttons lead you through the dialog pages.
The package execution is canceled. A confirmation prompt is always dis‐
played, which must be acknowledged. After a dialog is canceled, the "Finish"
dialog is always displayed, thus allowing the logbook to be backed up.
The cancellation process can take place immediately or after a time delay,
depending on the dialog page and the execution status.
Create MyConfig - Expert
4.4 Project folder
155