Table of Contents
Advertisement
Device Configuration
5.1
Device Configuration
This dialog provides an overview of the device configuration. It can, for example, be used for
system documentation.
Basic unit
SIMOCODE pro V PN as the basic unit.
Version
Firmware revision level for the selected basic unit:
● SIMOCODE pro V PN basic unit: Select V1.0, V1, V1.2 or V2.0
Thermistor
The basic units provide the option of connecting thermistor sensors (binary PTC) for
monitoring the motor temperature. See Thermistor parameters.
5.2
Module Configuration
For Pro V PN
● Current Measurement: If necessary, select the current measurement module with the
appropriate current range (depending on the Current module availability and Support
IUM/IUM V2), see Current range details in section 5.1, overload protection- Set current
(Page 23).
● Voltage measurement: Select here whether to use a current-voltage measurement
module for voltage, power factor (cos-phi) or real power monitoring.
● Voltage display: Please select either "Phase voltage" or "Line-to-line voltage" here
(default: phase voltage). This can only be activated if a current measuring module has
been selected.
● Digital module 1: Please select here, if a digital module with monostable, bistable or
safety outputs (DM-F Local and/or DM-F PROFIsafe) is to be used.
● Digital module 2: Select here whether to use digital modules with monostable or bistable
outputs.
● Operator panel: Select here whether to use an operator panel or not.
SIMOCODE PRO V PN FDI
Programming and Operating Manual, 05/2020, A5E44499659002A/RS-AA/001
5
17
Advertisement
Table of Contents
