Calibrating Speed - Husqvarna 967187001 Workshop Manual

Repair Work

7.20 Calibrating Speed

The test below assumes that points 1-5 in 7.17
have been completed.
IMPORTANT INFORMATION
Calibration may only be carried out with
fully charged batteries, rear wheel tire
pressure of 1.0 bar and the machine
standing on a roller bench.
1
Hold in the power button and then press the savE
button.
2
SaveE goes out, power and battery indicator flash.
3
Put the machine on a roller bed and
Accelerate the wheel to 205 ± 5 RPM.
(Only one roller is needed)
The front wheel can be strapped to the bed.
4
Depress savE, the wheels stop and calibration is
complete.
5
Turn the key to position 0.
After completed calibration, measure the rpm again
so that maximum RPM is OK.
60
English –