Replacing Brake Cable; Checking And Adjusting The Brake Cable; Changing Articulated Steering Bearing - Husqvarna 967187001 Workshop Manual

7.4 Replacing Brake Cable

For accessing the front and rear attachments,
dismantle any necessary covers, see "6.2"
1
Unhook the spring in the front part of the brake
cable.
2
Loosen the rear part and remove the brake cable.
3
Assemble the new wire in reverse order to
dismantling.
The new brake wire may require adjusting, see
"7.5"
7.5 Checking and Adjusting the Brake
Cable
To access the brake device, dismantle the rear
carriage, see "6.2"
The brake is properly adjusted when the brake
lever (1) is completely vertical. If it is not, adjust
the brake wire by pulling the rubber sleeve (2)
aside, loosening the clutch nut (3), adjusting
the nut (4) so that the lever arm is vertical, then
tightening the clutch nut (3) again.
If the brake does not apply despite the adjustment
described above, the brake disc can be adjusted
with the nut (6) at the top of the brake lever.
WARNING!
A poorly adjusted brake can
result in reduced braking ability.
7.6 Changing Articulated Steering
Bearing
1
Loosen the snap lock and remove the upper cover
on the rear carriage.
2
Unhook the articulated steering spring under the
machine.
WARNING!
The spring is strong.
Use spring tongs.
Repair Work
6
1
2
3
4
5
37
English –