Removing/Assembling The Cable Pulley - Husqvarna 967187001 Workshop Manual

Repair Work

7.3 Removing/Assembling the Cable Pulley

1
1
Loosen the rear fastening of the steering
cables (1).
2
Remove the screw (6) and the cable pulley (3).
3
Remove the bearing circlip (5) and tap out the
bearing (4).
4
Assemble the cable pulley in reverse order.
Bushing (2) is placed between the frame and the
cable pulley.
36
English –
7
2
3
4
5
6
Ensure that the cables are properly placed in the
steering cable pulleys (7).
Ensure that the steering wheel is in the center
position when the rear wheels are centered. Re-
set the chain on the steering column's sprocket or
adjust the rear fixture (1) for the steering cables as
needed.
Hold the cables with e.g. an adjustable wrench so
they do not twist.
After mounting, the cable tension should be
checked.