Removing Compressor Fasteners; Securing To The Floor Or Base; Lowering A Fan (Applicable To Downflow Units) - Huawei NetCol8000-A Series Quick Manual

Removing Compressor Fasteners

3.3
3.5

Lowering a Fan (Applicable to Downflow Units)

1.Remove the six screws and then the beam.
4.After the fan rotates to the position shown in the
figure, push the fan back to the horizontal position.
3.4

Securing to the Floor or Base

2.Rotate the fan upward by 30 degrees, and pull
the rotating shaft of the fan to the outermost side.
3.Slowly rotate the fan by 90 degrees and ensure that
the rotating shaft of the fan is on the outermost side.
Exercise caution when handling the fan to avoid body
injury.
5.Use a torque wrench to secure the two beams,
and interconnect the fan cables using the
interconnection terminal reserved in the cabinet.
6