Electrical Connection - Miele TWJ 660 WP Operating Instructions Manual

Electrical connection

The tumble dryer is supplied with a
mains cable with moulded plug ready
for connection to a suitable switched
socket.
The socket must be easily accessible
after the tumble dryer has been
installed. If that is not possible, ensure
that a suitable means of disconnection
is provided on the installation side for
each pole.

Risk of fire from overheating.
Connecting the tumble dryer to a
multi-socket plug adapter or to an
extension lead can overload the
cable.
For safety reasons, do not use an
extension lead or multi-socket plug
adapter.
The electrical system must comply with
local and national safety regulations
(BS 7671 in the UK).
If the connection cable is damaged, it
must only be replaced with a specific
connection cable of the same type
(available from your Miele dealer). For
safety reasons, such replacement may
only be carried out by a qualified
technician or your Miele dealer.
The data plate indicates the nominal
power consumption and the
appropriate fuse rating. Compare the
specifications on the data plate with
those of the electricity supply and make
sure that they match.
If in any doubt, consult a qualified
electrician.
Do not connect the tumble dryer to a
stand-alone inverter such as those used
with an autonomous energy source, e.g.
solar power. When the tumble dryer is
switched on, power surges could result
in a safety switch-off. This could
damage the electronic module.
Installation
79