Problem Solving Guide; The Display Indicates The Following Messages Or Faults - Miele TWJ 660 WP Operating Instructions Manual

Problem solving guide

Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Some of the messages in the display are more than one line long. Touch the  or
 sensor to read them in full.

The display indicates the following messages or faults

Message
000 lights up after
switching on.
Finish/Cooling down

Clean the plinth filter.
See  lights up
at the end of a
programme.
56
Cause and remedy
Access via a code has been activated.
 Enter the code and confirm the entry. Deactivate
the code if you do not wish this message to
appear in the display the next time the machine is
switched on.
The laundry will be cooled down at the end of the
programme.
 Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
The tumble dryer is not working correctly or
economically. Possible causes could be clogging
caused by fluff or detergent residue.
 Please see "Cleaning and care" for notes on
cleaning.
 Clean the fluff filters.
 Also check the plinth filter and clean it if
necessary.
 To switch off the message: confirm
You can influence when the
 message lights up.
 To do this, follow the instructions in "Airways
indicator – Settings".
OK .
Clean the plinth filter. See