Cleaning The Plinth Filter Access Panel; Cleaning The Dryer - Miele TWJ 660 WP Operating Instructions Manual

Cleaning the plinth filter access panel

 Use a damp cloth to remove any fluff.
Make sure that you do not damage
the rubber seal when doing this.
 Close the heat exchanger access
panel.

Damage or ineffective drying if
drying takes place without a plinth
filter or when the heat exchanger
access panel is open.
An excessive accumulation of fluff
can damage the tumble dryer. If the
system is not leak-tight, this can
make drying ineffective.
Only operate the tumble dryer with
the plinth filter fitted and the heat
exchanger access panel closed.
Cleaning and care

Cleaning the dryer

Disconnect the tumble dryer from the
electrical supply.

Damage due to the use of
unsuitable care products.
Unsuitable care products could
damage plastic surfaces and other
parts.
Do not use any solvents, abrasive
cleaners, glass cleaners, or all-
purpose cleaners.
 Clean the tumble dryer and the seal
on the inside of the door with a
slightly damp soft cloth and a mild
solution of washing-up liquid and
water.
 Dry all parts with a soft cloth.
55