Problem solving guide
Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Check indicators and fault messages
Problem
lights up after a pro-
gramme has been can-
celled and a signal
sounds
lights up at the end
of a programme
lights up
Bars flash in the display
at the end of a pro-
gramme:
.........
48
Cause and remedy
The condensed water container is full or there is kink
in the drain hose.
Empty the container.
Check the drain hose.
See "Cleaning and care".
To switch off:
Open and close the door (while the dryer is
switched on).
There is a build-up of fluff.
Clean the fluff filters.
Clean the plinth filter.
See "Cleaning and care".
To switch off:
Open and close the door (with the dryer switched
on).
You can influence when the indicator lights up: see
"Programmable functions", "Airways indicator ".
The programme selector has been moved.
Select the original programme. The time remaining
will appear in the display again.
The programme has finished but the laundry has not
yet cooled down.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.