Canon XU-81 Operation Manual page 35

④ AUTO switch
This switch is used to switch the shooting mode of the connected pan-tilt head camera.
When the LED is lighted, AUTO mode is selected. When the LED is off, MANUAL mode is selected.
Pressing this switch for over 2 sec switches to Super sensitivity mode*. The LED blinks in Super
sensitivity mode.
* Super sensitivity mode allows you to shoot bright images of subjects even at night or in dark
locations. The shutter speed and IR cut filter are adjusted automatically according to the sur-
rounding brightness.
⑤ AWB switch
This switch is used to perform auto white operation for the connected pan-tilt head camera.
When the switch is pressed, the auto white balance setting operation is started.
The LED (green) lights when the auto white balance setting is enabled. The LED goes off when
the manual white balance setting is enabled.
⑥ IS/WDR switch
This switch is used to switch the wide dynamic range function ON and OFF for the connected
pan-tilt head camera.When the wide dynamic range function is ON, the LED (green) lights.
⑦ SELECT switch
This selects IRIS, R GAIN, B GAIN, M-PED/EDGE (edge enchance-
ment function) or GENLOCK.
When the auto white balance setting is enabled, R GAIN and B GAIN
cannot be selected.
Each time the switch is pressed, the selection toggles in the order
of IRIS → R GAIN → B GAIN → M-PED/EDGE (edge enhancement
function), and the corresponding ⑧ LED (green) lights.
Press and hold the switch for 2 sec or more so that all four ⑧ LEDs
light to select GENLOCK. The selected item can be adjusted using the
⑨ - and + switches located below the SELECT switch. If you press
and hold this switch, the setting values will continue to change.
⑩ GAIN switch [enabled only in MANUAL mode]
This changes the gain setting of the pan-tilt head camera.
The shutter speed toggles in 5 steps each time the switch is pressed.
The setting is displayed in the ⑪ LEDs located above the ND. FILTER switch.
L H L
●○○ → ●●○ → ○●○ → ○●● → ○○●
0dB
6dB
⑫ ND. FILTER switch
This changes the setting of the ND filter built into the pan-tilt head camera.
The setting toggles in 2 steps each time the switch is pressed.
The setting is displayed in the ⑪ LEDs located above the ND. FILTER switch.
1 2
1 2
○○ → ●○
1/32
OFF
⑬ SHUTTER switch [enabled only in MANUAL mode]
This changes the shutter speed of the pan-tilt head camera.The shutter speed toggles in 5
steps each time the switch is pressed.
The setting is displayed in the ⑪ LEDs located above the ND. FILTER switch.
S F S
●○○ → ●●○ → ○●○ → ○●● → ○○●
2
1/15
H L H
12dB
F S F
1/60
E15
L H L H
18dB
42dB
S F S F
1/100 1/1000
IRIS
SELECT
R GAIN
B GAIN
M-PED
EDGE
+
-
Ex. GENLOCK selected
IRIS
SELECT
R GAIN
B GAIN
M-PED
EDGE
+
-
EX. B GAIN selected
SELEC
-