Canon XU-81 Operation Manual page 33

[Operating the pan-tilt head]
■ Pan and tilt operation
Perform pan and tilt operations by moving the ⑮ PAN/TILT operation lever to the front, back, right
and left.
Increase the lever angle to increase the pan and tilt operation speed.
■ Zoom operation
Perform WIDE/TELE operation by moving the ⑫ ZOOM operation lever to the right and left.
Increase the lever angle to increase the pan and tilt operation speed.
When the optical zoom limit is reached, the zooming operation momentarily stops. To transition to
digital zooming, keep pressing the lever toward the TELE side.
■ Focus operation
Press the ⑬ FOCUS operation knob to select AUTO or MANUAL.
When AUTO is selected
When MANUAL is selected → The AF LED goes off.
When MANUAL is selected, rotate the FOCUS knob to perform FAR/NEAR operation.
The focus changes in reference to the current lens state.
■ Wiper operation
Press the ⑯ WIPER switch. → The pan-tilt head housing wiper operates.
The wiper operates back and forth one time and then stops, even when the switch is held down.
The LED (green) lights while the wiper is operating.
■ Operating the washer
Press the ⑰ WASHER switch. → The external washer connected to the pan-tilt head operates.
Water is sprayed, and then the wiper operates and stops. The LED (green) lights while the wiper
is operating.
[Performing shot operations]
The pan-tilt head state, including the pan, tilt, zoom and focus positions, can be
stored in the memory using the eight ⑪ SHOT switches. Total of 32 shot positions
can be stored with the combination of pages A to D. Once shot positions are stored
in the memory, the pan-tilt head can be moved to the designated shot position by
pressing the corresponding SHOT switch number.
The movement time can be set using the ⑦ SHOT movement time adjustment
switches . The shot movement time is displayed in the ⑥ TIME display LED.
■ Storing shot positions in the memory
1. Press the ⑩ MEMO switch so that the MEMO LED (green) lights.
→ When the LED (green) is lighted, shot positions can be stored in the memory.
Each time the MEMO switch is pressed, the mode changes.
Shot valid (LED OFF) → Set in the memory (LED ON)
2. Use the PAN/TILT operation lever to move the pan-tilt head to the position to be stored in the
memory.
3. Press the ⑪ SHOT switch number corresponding to the memory in which the position is to be
stored.
→ When the LED of the shot number switch lights, the position is stored in the memory.
→ The AF LED lights.
E13
TIME
⑥
SECONDS
+
-
⑦