Details Of Operation And Functions; Pan-Tilt Head; Control Connectors - Canon XU-81 Operation Manual

5. Details of Operation and Functions

5-1. Pan-Tilt Head

5-1-1. Control Connectors

[Receptacle unit in the rear of the pan-tilt head]
①
DC cable
fastener
① MODE SW
Specify the transmission mode, installation type, and image format. After any changes, restart
the unit.
Switch
1
2
3, 4
5 to 7
8
② PWR LED
Lit in green when on.
③ DC-IN
Inlet for supplying DC power. Using the included power cord, connect the unit to a DC power
source suitable for the location of installation. (12 V, 30 W or more capacity recommended.)
④ RS-232C (see pin assignment at right)
A
n input for remote control. Connect one end of
an RS-232C cable here and the other end to the
operation unit.
Ensure that the cable connector can fit through an
opening 36.5 mm in diameter.
② ③ ④
⑩ ⑧
⑨
Transmission mode (OFF: RS-232C, ON: RS-422)
Installation type (OFF: upright installation, ON: suspended from a ceiling)
3（59.94/50）
OFF
ON
OFF
ON
Not used. Leave the switch set to OFF.
OFF: Normal mode, ON: high-speed mode
⑤
⑥
⑦
Setting Details
4（1080i/720p）
OFF
OFF
ON
ON
④ RS-232C（D-sub9P：DTE）
Pin No.
To connect a computer, use a cross-cable.
E10
Image Format
HD-SDI
1080/59.94i NTSC
1080/50i
720/59.94p NTSC
720/50p
Signal
2 RD (IN)
3 SD (OUT)
4 ER (fixed at +12V)
5 GND
7 RS (fixed at +12V)
⑪
⑫
VBS
PAL
PAL