Canon XU-81 Operation Manual page 34

■ Moving to a shot position
1. Press the ⑪ SHOT switch number corresponding to the desired position.
→ Shot operation starts. (The LED flashes while moving to the shot position.)
2. To stop the operation partway, press the ⑩ MEMO switch before the shot operation finishes.
→ Shot operation stops.
( ☆ Useful function)
Pressing the MEMO switch during shot operation stops the shot operation.
This is useful when you want to stop the shot operation partway.
(Reference information)
The ⑪ SHOT switches can be used as the AUX OUT and ICR switches.
When the ⑧ PAGE switch is pressed and held for 2 sec or more, the ⑨ PAGE LEDs (green) A
through D all light, and the switch functions change as follows.
[Adjusting the camera]
① CAMERA POWER switch
This switch is used to switch the power ON and OFF for the connected pan-tilt head camera.
When the camera power is ON, the LED (green) lights.
② PANEL LOCK
This switch is used to lock camera related operations to prevent accidental operation. Pressing
the switch lights the LED (green) and locks the camera related switches. When a disabled switch
is pressed in lock mode, the LED flashes to inform the operator of the locked status. Pressing
the switch again turns off the LED and unlocks the switches.
③ BAR switch
This switch is used to switch the output signal from the connected pan-tilt head camera.
When the LED (green) is lighted, BAR mode (internal color bar signal output from the connected
pan-tilt head camera) is selected.
When the LED is off, CAM mode (video signal output) is selected.
SHOT switch 1 → AUX OUT
SHOT switch 5 → ICR
CAMERA L H 1
POWER GAIN ND
PANEL
LOCK BAR AUTO AWB
2 S F
SELECT
SHUTTER
IS /
+
-
WDR
E14
IRIS
R GAIN
B GAIN
M-PED
EDGE