Toro Greensmaster Flex 1820 Operator's Manual page 15

1. Bedbar bolt
4. Remove each bedbar bolt, allowing you to
pull down the bedbar, and remove it from the
machine bolt (Figure
Account for the 2 nylon and 2 stamped steel
washers on each end of the bedbar
1. Bedbar bolt
2. Nut
Assembling the Bedbar
1. Install the bedbar, positioning the mounting ears
between the washer and bedbar adjuster.
2. Secure the bedbar to each side plate with the
bedbar bolts (nuts on bolts) and 4 washers (8
total).
3. Position a nylon washer on each side of the
side-plate boss. Place a steel washer outside
each of the nylon washers
4. Torque the bedbar bolts to 27 to 36 N∙m (240
to 320 inch-lb). Tighten the locknuts by hand
Figure 25
2. Locknut
25).
(Figure
Figure 26
3. Steel washer
4. Nylon washer
(Figure 26).
until the outside steel washer stops rotating and
there is no end play. The washers on the inside
may have a gap.
Important:
or they will deflect the side plates.
5. Tighten the spring tension nut until the spring
collapses, then back it off 1/2 turn
g014409
26).
1. Spring-tension nut
Installing the Bedknife
1. Remove the rust, scale, and corrosion from the
bedbar surface and apply a thin layer of oil to
the bedbar surface.
2. Clean the screw threads.
3. Apply never-seize compound to the screws and
install the bedknife to the bedbar.
g257517
15
Do not overtighten the locknuts
(Figure
Figure 27
2. Spring
27).
g014642