Toro Greensmaster Flex 1820 Operator's Manual page 12

Note:
For heights of cut greater than 13 mm (0.500
inch), install the high-height-of-cut kit.
Use the following chart to determine which bedknife is
best suited for the desired height of cut.
Recommended Bedknife/Height of Cut Chart
Bedknife Part Number
Edgemax 115-1880 (2100)
Micro-cut 117-1530 (1800)
(Standard)
Edgemax 115-1881 (2100)
Tournament 117-1532 (1800)
(Optional)
Micro-cut 93-4262 (2100)
(Optional) 98-7261 (1800)
Tournament 93-4263 (2100)
(Optional) 98-7260 (1800)
Extended 108-4303 (2100)
Micro-cut 110-2300 (1800)
(Optional)
Extended 108-4302 (2100)
Tournament
(Optional)
Low-cut 93-4264 (2100)
(Optional) 110-2301 (1800)
1. Loosen the locknuts securing the height-of-cut
arms to the cutting-unit side plates
1. Height-of-cut arm
2. Flange locknut
2. Loosen the nut on the gauge bar and set the
adjusting screw to the desired height of cut
(Figure 18).
Note:
The distance between the bottom of the
screw head and the face of bar is the height of
cut.
Height of Cut
1.5 to 4.7 mm
(0.062–0.188 inch)
3.1 to 12.7 mm
(0.125–0.500 inch)
1.5 to 4.7 mm
(0.062–0.188 inch)
3.1 to 12.7 mm
(0.125–0.500 inch)
1.5 to 4.7 mm
(0.062–0.188 inch)
3.1 to 12.7 mm
(0.125–0.500 inch)
4.7 to 25.4 mm
(0.188–1.00 inch)
(Figure
Figure 17
3. Adjusting screw
1. Gauge bar
2. Height-adjusting screw
3. Hook the screw head onto the cutting edge of
the bedknife and rest the rear end of the bar
onto the rear of the roller
17).
1. Gauge bar
4. Rotate the adjusting screw until the roller
contacts the front of the gauge bar.
5. Adjust both ends of the roller until the entire
roller is parallel to the bedknife.
Important:
front rollers contact the gauge bar and the
screw is snug against the bedknife. This
ensures that the height of cut is identical at
both ends of the bedknife.
6. Tighten the nuts to secure the adjustment
enough to remove play from the washer.
g278482
12
Figure 18
3. Nut
(Figure 19).
Figure 19
When set properly, the rear and
g000489
g016945