Setting Communications Parameters; Setting Parameters Before Using Webui Management; Optional) Setting Parameters Before Using The Neteco Management - Huawei TP48200A-HT19C4-1 Installation Manual

TP48200A-HT19C4-1 & TBC300A-TCA2
Installation Guide

10.7 Setting Communications Parameters

10.7.1 Setting Parameters Before Using WebUI Management

Procedure
Step 1 Apply to the site or equipment room network administrator for a fixed IP address.
Step 2 Set the IP address, subnet mask, and gateway on the LCD, as shown in
Table 10-5 IP parameters
Second-
Main Menu Level Menu
Setting Network
Wizard Parameters
----End
10.7.2 (Optional) Setting Parameters Before Using the NetEco
Management
Networking Mode 1: over FE Port
Step 1 Apply to the site or equipment room network administrator for a fixed IP address.
Step 2 Set the IP address, subnet mask, and gateway on the LCD, as shown in
Table 10-6 IP parameters
Main Second-
Menu Level Menu
Setting Network
Wizard Parameters
Issue 01 (2014-03-12)
Third-Level
Menu Default Value
IP Address 192.168.0.10
Subnet Mask 255.255.255.0
Default Gateway 192.168.0.1
Third-Level
Menu
Default Value
IP Address 192.168.0.10
Subnet Mask 255.255.255.0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Commissioning
Table 10-5.
Setting Value
Set this parameter according to
the IP address assigned by the
network administrator.
Set this parameter according to
the subnet mask provided by the
network administrator.
Set this parameter according to
the gateway address provided by
the network administrator.
Table 10-6.
Setting
Set this parameter according to
the IP address assigned by the
network administrator.
Set this parameter according to
the subnet mask provided by the
network administrator.
76