Yamaha MTX Series Setup Manual page 5

Example 4) A system using Dante
In this example, existing amps continue to be used, while we set up a new system at a distant location, with connec-
tions made using Dante.
The system using the existing amps is labeled System A, and the new system is labeled System B.
In example 4, our explanation will be centered on the network settings. For more about increasing the number of
mics, DCP settings, or presets, refer to example 2.
Network Switch for MTX-MRX Editor
System A
Microphone Ch1
This example assumes that you're using the following equipment.
System A
• MTX5-D × 1
• Exi8 × 1
• EXo8 × 1
• Amplifiers (eight channels of amplification)
• Network switch × 1
• Speakers (the number needed)
• SD memory card × 1
• Paging microphones with switch × 1
* As the network switch for Dante connections, we recommend that you use a model that provides IGMP snooping
functionality.
The number of speakers is not specified; choose amps that are suitable for your speaker setup. You will also need to
provide the appropriate number of cables.
EXi8 ID=02
MTX5-D ID=01
Power Amp 3
Power Amp 4
Amp
Room A
Amp
Room B
EXo8 ID=03
Power Amp 1
Power Amp 2
System B
Network Switch for Primary
Network Switch for Secondary
System B
Microphone Ch1
• MTX5-D × 1
• XMV4280 × 1
• XMV4280-D × 1
• Network switch × 2*
• Speakers (the number needed)
• SD memory card × 1
• Paging microphones with switch × 1
Introduction
MTX5-D ID=04
XMV4280 ID=30
Amp
Room A
Amp
Room B
XMV4280-D ID=31
5
MTX Setup Manual