Yamaha MTX Series Setup Manual page 127

4.
Set the [UNIT ID] rotary switch and DIP switch of the devices.
Set the computer's IP address after completing the wizard, in
If the MTX, XMV, or PGM1 are not nearby, you can set them during the step
Make the following settings.
MTX5-D
XMV
XMV
NOTE
Use the DIP switch to specify the upper digit of the UNIT ID, and use the [UNIT ID] rotary switch to specify the lower digit. For
details, refer to the owner's manual or installation manual of each unit.
UNIT ID = 01
UNIT ID = 30
UNIT ID = 31
UNIT ID = 3 1
Lower digit: specify using the rotary switch
Upper digit: specify using DIP switch 1–3
Example 5) A system using the PGM1 for paging
"Specifying the computer's TCP/IP address."
"Connecting the equipment."
[UNIT ID] rotary switch = 1
DIP switches = all OFF (upward)
[UNIT ID] rotary switch = 0
DIP switches = 1 and 2 ON (downward), others OFF (upward)
[UNIT ID] rotary switch = 1
DIP switches = 1 and 2 ON (downward), others OFF (upward)
127
MTX Setup Manual