Yamaha MTX Series Setup Manual page 150

Power-on the PoE-equipped gigabit network switch
The PGM1 starts.
Power-on equipment other than amps and powered speakers
Power-on equipment other than amps and powered speakers.
When powering-off equipment other than amps and powered speakers, start by powering-off the amps and powered speak-
ers.
Power-on amps and powered speakers
Power-on amps and powered speakers.
To prevent unwanted sound from being output, we recommend that you minimize the attenuator settings of all channels on
the amp or powered speaker itself before you turn it on.
Specifying the computer's TCP/IP address
To allow the MTX and the computer to communicate, specify the computer's TCP/IP as follows.
1.
On MTX-MRX Editor's [System] menu, click [Network Setup].
The "Network Setup" dialog box will appear.
2.
Click [Open Network Connection].
"Network Connections" will appear.
3.
Right-click the adapter to which the MTX is connected, and choose [Properties].
The "Local Area Connection Properties" dialog box will appear.
4.
Choose [Internet Protocol Version 4 (TCP/IPv4)], and then click [Properties].
The "Internet Protocol Version 4 (TCP/IPv4) Properties" dialog box will appear.
5.
Click [Use the following IP address (S)].
Example 5) A system using the PGM1 for paging
MTX Setup Manual
150