Yamaha MTX Series Setup Manual page 13

8.
When you see the dialog box "Display the configuration diagram? The diagram can also
be printed." click [Yes].
A cabling diagram will appear. If you want, click [Print] to print the diagram.
To close the screen, click [Close].
Set the DIP switches of the DCP units as shown in the "Digital Control Panel" section of the schematic diagram.
For the last DCP (ID=3), set DIP switch 4 ON (upward).
ON
1 2 3
NOTE
If you want to view the cabling diagram again, do so by choosing [File] menu → [Print Configuration Diagram].
If you want to use the Device Configuration Wizard to change the device configuration, click the [Device Config] but-
ton in the Project screen.
4
Example 1) Basic MTX3 system example (analog connections)
13
MTX Setup Manual