Yamaha MTX Series Setup Manual page 43


Settings in the "MATRIX" screen
Here you can specify which input channel will be sent to which zone. For details on send level and other parameters,
refer to "MTX-MRX Editor User Guide."
In this example, make the settings shown in the above illustration. Clicking a cross point (a square area) or dragging
cross points will switch it on/off. If you right-click on a cross point, a context menu appears. You can select [All OFF]
to turn off all cross points. The cross point shows the send level as the amount of green.
With the settings shown here, the two microphones in hall A (CH3 and 4) are broadcast only to hall A. In addition, CD/
BGM/SD (STIN1–3) are being broadcast to the entire building. The microphone in the entrance (CH1) is assigned to be
broadcast to the entire building in the event of an emergency, and is therefore assigned in the "ZONE" screen
st
(described next) as 1
the signal from Priority will be combined and output. Similarly, the microphone in the kitchen (CH2) is assigned as 2
PRIORITY that is valid only in zone 4 (Kitchen), and therefore is not specified in the matrix.
For the input channel faders in the lower left of the screen, the grayed-out faders show input levels, and the other faders
show input channel send levels. Grayed-out faders cannot be operated in this screen.
Priority signal flow
Example 2) High audio quality system with XMV and YDIF connections (digital connections)
PRIORITY. If channel 1 is turned on in the matrix, the signal from the matrix (attenuated) and
ZONE 1-8
From INPUT CHANNEL POST ON 1-8
From STEREO INPUT CHANNEL POST ON 1L-3R
From DIRECT INPUT POST ON 9-16
From ANC BUS 1-2
*1 From YDIF IN 1-16
*1 DISTRIBUTION MODE only
2nd PRIORITY 1st PRIORITY ANC
GR GR
PRIORITY PRIORITY
ANC
DUCKER DUCKER
MIX MIX
AMBIENT
METER
PRIORITY PRIORITY AMBIENT
SOURCE SOURCE SOURCE
ZONE OUT
MASTER
METER
LEVEL
D ON
C
8
A
To YDIF
OUTPUT
PATCH
To other MTXs
MTX Setup Manual
nd
43